I do not find out about you however I like bringing new life to outdated issues (re: my obsession with property gross sales and all of the furnishings I’ve refinished). When I discovered these lamps at an property sale for $10 a bit, I knew I might rework them into one thing stunning by including this Braunschweig & Fils material and a few velvet ribbon. In an hour and a half, you’ll be able to discover ways to cowl a lampshade with material on this simple fabric-covered lampshade DIY tutorial. These had been the proper ending touches to my visitor bed room transformation for the One Room Problem.
For this tutorial, you may want a lampshade, a scorching glue gun, some velvet ribbon (I used 3/8″), 1 yard of cloth (I used Lace Contact from Brunshwig and Fils), and a few persistence.
The best way to cowl a lampshade with material
Step 1: Minimize your material
A very powerful factor is to chop. When you’re making a cone-shaped round lower it’s important that you simply get the correct angle for match. To attain this, begin with the seam lining up the sting of the material after which roll the lampshade whereas tracing with a pencil till you attain the seam once more.
The hot button is NOT to chop on these traced traces!!! As a substitute, lower about 1-1.5 inches round this line so you’ve got room to tuck the material underneath the sting of your lampshade.
If retrieving two lampshades, use your first lower to hint and lower the second lampshade from the material. If utilizing a patterned material, make certain the material is oriented the identical approach as the primary lower so the sample matches.
Step 2: Dry the material with the lampshade.
Align the seam of the lampshade with the sting of the material and “dry match” the material across the lampshade to make sure a cosy match. We would like the material to overlap across the seam.
Step 3: Connect the material to the highest with scorching glue.
With a scorching glue gun, beginning the place the seam begins, press and cling your material to the highest opening. As I did this, I lower small slits within the prime to have the ability to stretch and press the material upwards. Be sure to have sufficient hanging right down to cowl the underside fringe of your lampshade.
Step 4: Safe the highest across the seam. Be sure that the material seams overlap.
Step 5: Connect the material to the underside with scorching glue.
Begin on the backside and add scorching glue to the bottom whereas pulling the taught material so far as attainable. The tighter and straighter the material will match the lampshade. Repeat in smaller sections across the base of the lamp till you attain the seam.
Step 6: Safe the seam.
Take your material the place it exhibits and fold it flippantly over itself, then scorching glue the seam from prime to backside by urgent firmly.
If including velvet trim, proceed to step 7, in any other case go to step 8.
Step 7: Begin your velvet trim on the seam and safe with a dot of scorching glue.
Utilizing your thumb as a information for the sting, add scorching glue and press your ribbon towards the sting and press together with your index finger. Repeat all the way in which across the perimeter after which lower the ribbon to fulfill the sting of the seam. Repeat for the underside edge.
Step 8: Tidy up the inside.
Safe with extra scorching glue and trim the surplus material on the within, trimming any scorching glue strings within the course of.
I hope you discovered this fabric-covered lampshade DIY tutorial useful! For those who want extra clarification, do not hesitate to get in contact or go away a remark under.
Watch the total video tutorial right here on Instagram.
If a fabric-covered lampshade DIY is not your factor, you’ll be able to store some alternate options under.
